Storage - EASYmaxx 12126 Gebrauchsanleitung

EN
in liquid form at room temperature and
under slight compression in a gas cartridge.
When the gas cartridge is opened, the pres-
sure escapes, the liquid expands and turns
into a gaseous state.
1. Place the device on a stable, horizon-
tal and level surface. Ensure there is
sufficient clear space on all sides. When
you choose the location for setting up
the device, follow the "Safety Notices"
chapter.
2. Make sure that the control knob (5) is in
the OFF position and the lever for lock-
ing the gas cartridge in place (6) is at the
top in position
cartridge cannot be locked in place.
3. Open up the lid of the gas cartridge
compartment (4).
4. Remove the cap from the gas cartridge.
5. Insert the gas cartridge into the gas car-
tridge compartment (Picture B): Place
the valve of the gas cartridge into the
gas connection (8). The recess in the rim
of the gas cartridge points upwards.
6. Close the lid of the gas cartridge com-
partment (Picture C).
7. Push the lever for locking the gas
cartridge in place down to position
to lock the gas cartridge in place in the
device and open the gas supply (Pic-
ture D).
If you hear a hissing noise, the gas
cartridge is not connected correctly.
In this case, do not ignite the device,
but instead move the lever upwards and
repeat the process of inserting the gas
cartridge.
14
. Otherwise the gas
Leak Test
To check the seal between the device and
gas cartridge or to uncover any leaks, use
a commercially available leak detector agent
and follow the manufacturer's instructions.
Performing a leak test by listening is not
safe!
1. To ignite the burner (1), turn the control
knob all the way down to the IGNITION
position (Picture E). The gas supply is
activated and a spark is generated at the
same time, which produces a popping
sound.
2. If the burner has not ignited, turn the
control knob to the OFF position and try
again after around 2 to 5 minutes.
3. If the flame burns (Picture F), a pot or
pan can be placed on the pan support
(Picture G).
4. Use the control knob to adjust the size
of the flame between the MAX and
MIN positions.
5. Turn the control knob to the OFF posi-
tion to switch off the device.
6. If the flame has gone out, slide the lever
for locking the gas cartridge in place up
to position to shut off the gas supply
(Picture H).

STORAGE

Please Note!
■ Store the device and gas cartridges out
of the reach of children and animals.
1. Allow the device to cool down. Then
remove the gas cartridge and seal it shut
with the cap.
2. Store the device in the storage case
that comes with it in a cool, dry place
(Picture I).
3. Store the gas cartridge in a dry, cool
place that is well-ventilated and protect-
ed from sunlight.