Important - Coffee Queen QUEEN PEARL Bedienungsanleitung

7. Important

WATER LINE
Important
Do not make any alterations to the machine. Doing so may result in personal injury and cause the
machine to break down.
The machine should stand on a flat surface so that it will function properly.
The machine must be placed on a surface that is impermeable to water so that any leaks
will be visible. Make sure that no kinks are formed in the hose during installation or when
machine is moved into position. The machine's hose and HVAC connections must be checked
on a regular basis. Make sure that no leakage has occurred in connection with installation.
With a water connection, there is always a danger of leakage, regardless of any safety equipment
used.
If the machine is to be put into storage for an extended period of time, it must be completely
drained of water.
Shut off the water taps if the machine is not to be used for an extended period of time.
Before carrying out any maintenance, the machine must be disconnected from the mains
electricity supply by pulling the plug from the wall socket.
CHILLER SYSTEM
INSTALLATION AND SITING:
The system is designed to be used in standard environments in accordance with
CSN standard 33 2000-3 and is included in climate class N.
It must not be sited close to a heating source or exposed to direct sunlight.
The system is designed to be used in ambient temperatures of
between 6°C (minimum) and 28°C (maximum).
The system must not be used or sited in areas with an ambient temperature below 0°C.
ELECTRICAL CONNECTION
Connect the system to 220–240 V, 50 Hz and 10 A. The electrical installation plug must be compliant
with applicable CSN regulations, EN and ISO standards. If the cable is damaged, it must be
replaced by qualified personnel. This is to prevent accidents.
TEMPERATURE AND SETTINGS:
The temperature of chilled drinks is controlled by means of a mechanical temperature regulator
between 3°C and 10°C. There is a scale from 1 to 7 on the temperature regulator.
(1 = approx. 10°C, 7 = approx. 3°C, 0 = off).
CONNECTION AND SERVICE:
The condenser shall be cleaned every 6 months in conjunction with replacing the water filter.
When cleaning, use compressed air. Do not place anything on the chiller that may hinder air circulation.
Only clean when the chiller is not under power!
All installation work must be carried out by qualified personnel.
12.