Me FG-6.3 RX Betriebsanleitung Seite 19

Changing the system code
In rare cases, the code of your system may overlap with that of a neighbour. In
this case it is necessary to change the code(s).
1. Remove the battery from the transmitter.
2. Wait about 10 seconds and reinsert the battery.
3. Remove the batteries from the FG-6 RX.
4. Wait approx. 30 seconds.
5. Reinsert the batteries. The FG-6 RX emits a double beep and is in learning
mode.
6. Activate the transmitter, e.g. by pressing the bell button of the additional
transmitter or knocking on the sensor module of the sound-active
transmitter.
7. The FG-6 RX plays a melody.
Existing additional transmitters must also be given a new code and relearned.
To do this, remove the batteries from all transmitters for approx. 10 seconds and
then carry out the steps for "Pairing additional transmitters".
19
ENGLISH FG-6.3 RX
GB