Initial Start-Up; Adjusting The Volume - Me FG-6.3 RX Betriebsanleitung

ENGLISH FG-6.3 RX

INITIAL START-UP

The FG-6 RX is operated with 2 batteries of the type "AA" (not included in deliv-
ery). Open the battery compartment (9) on the back and insert the batteries
according to the polarity markings. The unit emits a double beep and is ready to
learn a transmitter. Start up the transmitter (see transmitter instructions) and
activate it, e.g. by pressing the bell button or tapping on the sensor module of
the sound-active transmitter. The FG-6 RX plays a ring tone as confirmation.
Setting the ring tone
The ring tone is selected via the paired transmitter. This makes it possible to
assign an individual ring tone to each transmitter. Each transmitter has a small
button marked "S" for this purpose. Each time the button is pressed, the next
ring tone is played at the receiver. Wait until the ring tone has been played com-
pletely before pressing the button again. The last ringtone played is automatic-
ally saved. For further information, please refer to the instructions of the trans-
mitter.

Adjusting the volume

GB
The volume can be varied in 4 steps using the Volume + (3) and - (4) buttons on
the side. Pressing the Volume + button increases the volume, pressing the
Volume - button decreases the volume. The volume is saved automatically.
17