Further Settings; Mode Switch - Me FG-6.3 RX Betriebsanleitung

ENGLISH
FG-6.3 RX

FURTHER SETTINGS

MODE switch

The MODE switch (6) on the side can be used to select between 3 different oper-
ating modes:
1. Sound + Light: The ringing melody is played and the LEDs flash
2. Light: Only the LEDs flash
3. Sound: Only the ringing melody is played
Pairing additional transmitters
Each receiver can learn a total of 4 transmitters. To tune in an additional trans-
mitter, carry out the following steps:
1. Press the CODE button (5) on the receiver for approx. 2 seconds, the receiver
then beeps once and is in learning mode.
2. Activate the transmitter to be learned within 4 seconds, e.g. by pressing the
GB
bell button of the additional transmitter or knocking on the sensor module of
the sound-active transmitter.
3. The receiver plays a melody, the additional transmitter is learned and the
receiver switches back to normal mode.
Repeat these steps for all transmitters that are to be tuned in, max. 4 transmit-
ters are possible.
Note: If you do not press the bell button of the transmitter within 4 seconds
after activating the learning mode, the learning mode of the receiver deactivates
itself and acknowledges this with a signal tone.
Note: Each time the batteries are changed, the code memory in the FG-6 RX is
deleted and all transmitters must be relearned.
18