Reset Beosound A5 - Bang & Olufsen BeoSound A5 Bedienungsanleitung

RESET BEOSOUND A5

Wi-Fi setup mode
To disconnect Beosound A5 from the current Wi-Fi
network and connect it to a new one, press and hold [ ]
buttons at the same time for two seconds. The indicator
light will start flashing orange, and the speaker is ready to
be connected via the Bang & Olufsen app.
To cancel Wi-Fi setup and connect back to the previous
network, press and hold the buttons again.
Note: If your Beosound A5 is currently stereo paired,
pressing and holding the buttons will instead separate the
pair. Once the stereo pair has separated, press and hold
the buttons again to enter Wi-Fi setup mode.
Hardware reset
If your Beosound A5 becomes unresponsive, press and
hold the power button [ ] for 20 seconds to reset the
hardware and restart the product. This is not a factory
reset – your settings will not be erased.
Restore factory settings
To erase all settings and reset Beosound A5 to factory
default settings, press and hold [ ] buttons at the same
time for 8 seconds. Once the speaker has restarted and
the light indicator flashes orange, it is ready to be set up
again via the Bang & Olufsen app.
18