Herunterladen Inhalt Inhalt Diese Seite drucken

Fellowes POWERSHRED P70CM Bedienungsanleitung Seite 3

Vorschau ausblenden Andere Handbücher für POWERSHRED P70CM:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
BASIC SHREDDING OPERATION
Continuous operation:
2-4 minute maximum
NOTE: Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond 2-4
minutes will trigger a 20-minute
cool down period.
TROUBLESHOOTING
Paper jam: Set to Off (O) and empty bin. Replace bin and follow any or all of the below procedures.
1
2
Set to Reverse
Gently pull uncut
(R) for 2-3
paper from paper
seconds
entry.
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
stop running. To avoid these problems, we recommend you
oil your shredder each time you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
7
PAPER/CARD
1
2
Set to On (I)
Feed into paper/card
entry and release
7
7
3
4
Alternate slowly back and forth
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to On (I)
7
7
2
3
Set to Reverse (R)
Apply oil*
for 2-3 seconds
across entry
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain
service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Make sure switch is in ON position (I).
Make sure head is on basket correctly.
Check for jam.
Remove and empty basket.
7
Wait 20 minutes for motor to cool down.
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis