Video Cable For Graphics Control Board - HEIDENHAIN BC 110BF Betriebsanleitung

Overview of video cables | Video cable for graphics control board
16.3

Video cable for graphics control board

You can use the existing video cable of your machine.
For your new cable please use a well-shielded 12-pin computer cable.
Cable type:
Length:
For the new cable the graphics control board must be modified to
version 2 or higher, as can be seen from the lower handle (30112)
The signal ground (GND) must not be connected to the shield
Only use shielded connector housings
Your cable should only be as long as necessary, with a little allowance
for mounting and dismounting the monitor
HEIDENHAIN | User's Manual TFT-Monitor 12,1" | 06/2022
6 x 2 x 0.14 mm²
max. 20 m
69