Safety Regulations; Layout And Items Supplied - Kraissmann MS'560 Betriebsanleitung

ENGLISH
Danger!
When using the equipment, a few safety precautions must
be observed to avoid injuries and damage. Please read the
complete operating instructions and safety regulations
with due care. Keep this manual in a safe place, so that
the information is available at all times. If you give the
equipment to any other person, hand over these operating
instructions and safety regulations as well. We cannot
accept any liability for damage or accidents which arise
due to a failure to follow these instructions and the
safety instructions.

1. SAFETY REGULATIONS

The corresponding safety information can be found in the
enclosed booklet.
Danger! Read all safety regulations and instruc-
tions. Any errors made in following the safety
regulations and instructions may result in an
electric shock, fi re and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Safety devices
When working with the equipment, the appropriate plastic
guard hood for cutting blade mode or cutting line mode
must be fi tted to prevent objects being thrown out by the
equipment. The integrated blade in the cutting line guard
hood automatically cuts the line to the optimum length.
Explanation of the warning signs on the equipment
(Fig. 16):
1. Warning!
2. Read the directions for use before operating the equip-
ment.
3. Wear protective headgear, goggles and ear muffs.
4. Wear sturdy, non-slip footwear.
5. Wear safety gloves.
6. Protect the equipment from rain and damp.
7. Be careful of objects being thrown out!
8. Always switch off the equipment and pull out the spark
boot plug before carrying out any maintenance work.
9. All bystanders must be kept at least 15 m from the
machine.
10. The equipment continues to rotate!
11. Caution: Hot equipment parts. Keep your distance.
12. Add a little grease (gear grease) after every 20 hours
in operation!
13. Beware of recoil!
14. Do not use any saw blades.
2. LAYOUT AND ITEMS
SUPPLIED
2.1 Layout (Fig. 1-13)
1. Guide pin adapter
2. Guide pin
3. Operating handle
4. Starter cable
5. Choke lever
6. Gas tank
7. Fuel pump (primer)
8. Air fi lter housing cover
9. ON-OFF switch
10. Throttle lever lock
11. Throttle lever
12. Locking knob for throttle lever
13. Spool with nylon line
14. Nylon line protective hood
15. Cutting blade safety cover
16. Air fi lter
17. Carrying strap
18. Cutting blade
19. Operating handle retainer
20. Spark plug connector
21. Handle screw M6
22. Driving plate
23. Pressure plate
24. Pressure plate cover
25. Nut M10 (left-hand thread)
26. Measuring jug
27. Spark plug wrench
29. Allen wrench 4 mm
30. Allen wrench 5 mm
2.2 Items supplied
Please check that the article is complete as specifi ed in
the scope of delivery. If parts are missing, please contact
our service center or the sales outlet where you made
your purchase at the latest within 5 working days after
purchasing the product and upon presentation of a valid
bill of purchase. Also, refer to the warranty table in the
service information at the end of the operating instruc-
tions.
▶ Open the packaging and take out the equipment with
care.
▶ Remove the packaging material and any packaging and/
or transportation braces (if available).
▶ Check to see if all items are supplied.
Grass trimmer | 15