Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Switch off the engine IMMEDIATELY if you realise
that there are strong vibrations. In case of vibrations,
serious problems might be ahead. Before you go on
working, carefully examine the tool for loose screws
and nuts and for possible defects. Repair or replace
the affected parts if required.
After operation
•
Clean the blade with a household cleaner to remove
mastic pitch/resin which might be on it. Then lubricate
the blade using machine oil to avoid the formation of
rust.
•
Lock the blade in a proper place to protect it from
unauthorised use.
•
Lock the brushcutter in a proper, dry room to protect
it from unauthorised use and damage.
10. Maintenance of the gear (
1. Check the lubricant of the gear every 50 operating
hours.
2. To check the lubrication of the gear unscrew the filler
plug. If you cannot see any grease in the lubricator
bore use a grease gun or commercially available
grease tube to refill grease until it comes out of the
bore. Afterwards, carefully screw-in the filler plug
again. Use a commercially available gear grease to
lubricate the gear.
11. Trouble Shooting
• Tool does not work: Check power supply (e.g. by
testing on another socket or by means of a voltage
tester). Should it still not work, although the socket
is o.k., send it undismantled to an authorised service
station for repair.
Do not make any other repairs on your own; have your
tool checked and repaired by an authorised service
station.
12. Storing
•
Clean the unit thoroughly, especially the cooling air
slots on the motor housing.
•
Do not use water to clean the device.
•
Store trimmer indoors in a dry, high or locked place
and keep out of reach of children.
13. Waste disposal and environmental protec-
tion
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but dis-
pose of it in an environmentally friendly manner. Please
dispose of the device itself at an according collecting/re-
cycling point. By doing so, plastic and metal parts can
be separated and recycled. Information concerning the
disposal of materials and devices are available from your
local administration.
fig. 20)
GB-6
14. Repair saervice
Repairs to electric power tools should only be carried out
by a specialised electrician.
Werbung
Inhaltsverzeichnis
