Logging Duofern Transmitters On / Off - RADEMACHER 9471-3 Gebrauchsanleitung

i

10. Logging DuoFern transmitters on / off

For the DuoFern Tubular Motor Actuator 9471-3 to be operated
with a DuoFern transmitter, you must log each desired transmitter
onto the DuoFern Tubular Motor Actuator 9471-3. You can log
on a maximum of 20 DuoFern transmitters (e.g. DuoFern Manual
Transmitter Standard, etc.).
1.
Switch the desired DuoFern transmitter to log-on/log-off mode
(please refer to the respective instruction manual).
2.
Press the "Connect button" [
button" [
3.
The actuator then transmits either a log-on or log-off signal.
Log-on / log-off mode remains active for 120 seconds.
4.
After successfully logging on / off, the STATUS LED
lights up green for approx. 4 seconds.
5.
Log on / log off the next DuoFern transmitter. To do so, repeat
steps 1 to 3 or else terminate the log-on / log-off process.
Observe the STATUS LED
The STATUS LED lights up red if the log-on / log-off process fails,
for example if:
◆ 20 DuoFern transmitters have already been logged on
◆ An unsuitable device (e.g. other DuoFern actuator) is
logged on.
◆ An attempt was made to log off a DuoFern transmitter that
is not logged on.
] of the DuoFern Tubular Motor Actuator 9471-3.
] or the "Disconnect
EN
49