Celestron THERMISTOR 94037 Bedienungsanleitung Seite 2

Connect the thermistor's plug to the thermistor port corresponding to the
dew heater port you are using on the controller (Figure 2). Once the thermistor
is connected, the controller will automatically adjust the power to the heating
band based on the data from the thermistor and the controller's environmental
sensor.
Each dew heater port on the controller can deliver a maximum of 84W power
(7A max current), which should be more than enough for most dew heating
bands or strips. For more information about automatic "smart control" of
a dew heater, refer to the instruction manual included with your Celestron
Smart DewHeater Controller.
Fig. 2: Connect the thermistor's plug to the thermistor port corresponding to the dew heater port
you are using on the controller
SPECIFICATIONS: Thermistor plug: 2.5mm Audio
©2022 Celestron. Celestron and Symbol are trademarks
of Celestron, LLC. All rights reserved. Celestron.com
2835 Columbia Street, Torrance, CA 90503 USA
This product is designed and intended for use by those 14
years of age and older.
Made in China
FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Product design and specifications are subject to change without prior notification. This product is designed and intended for use by those 14 years of age and older.
celestron.com/pages/warranty
11-22