Cilio VENTO 27 Bedienungsanleitung Seite 13

Assembly of the stand
1. Pull the cable from above through the opening in the base plate.
2. Insert the stand into the opening in the base plate from above, taking into account the recesses.
3. Tighten the stand clockwise until it clicks into place (bayonet lock). Only when the stand is fully engaged, the
openings for cable guiding are open in one row.
4. Lay the cable through the guide openings so that the fan stands securely.
Assembly of the grille and the wing
1. Unscrew the lock nut of the grille.
2. Now place the rear grille on the motor shaft. Make sure that the handle is facing up and that the elongated
recesses are vertical, so that the lower pin fits into the vertical recess. Fix the rear grille with the grille lock nut
(even side facing forward), hand-tighten the lock nut clockwise.
3. Now place the wing (even side facing forward) on the motor shaft. Hold the motor housing with one hand and
use the other hand to push the wing completely onto the motor shaft. Check whether the wing can turn freely.
4. Attach the cover with the screws hand tight to the front side of the front grille.
5. Place the fastening ring around the rim of the rear grille. First, loosen the screw at the bottom just enough so
that the ring can easily be pushed onto the rim.
6. Now insert the front grille into the fastening ring. Press the two grille parts together all around. Make sure that the
rims of the two grilles are together within the ring, that the front side of the grille is facing you and that the logo
is in the correct position.
7. Fix the fastening ring with the screw hand tight.
8. Your fan is now ready for use.
13