Controls - BORETTI SOFFITTO X 100 Gebrauchsanweisung

Controls

1: Power level higher (+)
2: On/Off motor
3: Power level lower (-)
4: On/off lighting
5: Led
Note: the LED on the hood indicates the various speeds: green
1st speed, orange 2nd speed, red 3rd speed and flashing red
4th speed. All hoods with capacities exceeding 650 m3/h have
the last timed speed; It lasts for 7 minutes, after which it
automatically returns to the last non-timed speed.
Simultaneously pressing buttons 2 and 4 enters the light intensity variation mode
(the LED on the hood will flash green), buttons 1 and 3 vary the intensity. To exit
this function and return to normal remote control functions, press button 2 or 4 or
wait 20 seconds.
Simultaneously pressing buttons 2 and 4 twice in succession enters the light tem-
perature variation mode, which can vary from 2700 to 6000 °Kelvin (the LED on
the hood will flash orange), buttons 1 and 3 vary the light temperature. To exit this
function and return to normal remote control functions, press button 2 or 4 or wait
20 seconds.
Initialization procedure:
1. Cut off power to the hood
2. Power the hood again
3.Within the first 5 sec, press the light button and release it after the lights turn on
(the control must be turned on via key 3)
4. Within 5 sec, press the motor key and release it
Now you have to wait for about 10 seconds – then you can use the hood normally.
Notes: after 4 hours from the last use of a key, the hood turns off automatically.
Should there be interferences with other nearby remote controls, carry out the
code change procedure. Should it be required to replace the radio control, the fre-
quency of the electronic system of the new radio control must be calibrated again
via the initialization procedure.
29