Spare Parts; Disassembly, Disposal - haacon 4216.0,25 Betriebsanleitung

10. INspeCTIoN
The equipment must be inspected in accordance with the conditions of
use and the operating conditions at least once per year by an authorised
person for testing per TRBS 1203 (Technical expert) (testing per BetrSi-
chV, §10, sect.2 represents implementation of EC Directives 89/391/EEC
and 2009/104/EC and the annual occupational safety inspection per
DGUV-V 54, §23, sect. 2 and DGUV-G 309-007).
These inspections must be documented:
– Before commissioning.
– After significant alterations before recommissioning.
– At least once per year.
– In the event of unusual occurrences arising that could have detrimen-
tal effects on the safety of the winch (extraordinary tests, e.g. after a
long period of inactivity, accidents, natural events).
– After repair works that could have an influence on the safety of the
winch.
Technical experts are persons, who have sufficient knowledge based
on their specialist training and experience, in the areas of winches, lift
and pull systems and the relevant official occupational health and safety
rules, accident prevention regulations, guidelines and generally ac-
cepted engineering rules (e.g. EN standards), to evaluate the opera-
tional safety of winches, and lift and pull systems. Technical experts are
selected and comissioned by the operator of the equipment.
11. mAINTeNANCe reCommeNDATIoN
The operator determines the intervals themselves based on frequency
of use and the operating conditions.
– Regular cleaning, no steam jets!
– Carry out visual check on inaccessible brakes / locks every 5 years at
the latest, replace brake pads as required.
– General overhaul by the manufacturer after 10 years at the latest.
094007_o_gb_seilwi_s haacon hebetechnik gmbh . Phone +49 (0)9375 - 84-0 . Fax +49 (0)9375 - 8466
CAUTIoN!
Only perform inspection, maintenance and repair work on an
unloaded hoist. Only allow work on brakes and locks to be per-
formed by qualified specialist personnel.
maintenance and inspection work
Visual check of the rope hooks (load carrier)
Function of the winch
Condition of the rope and lifting equipment
Brake function under load
Grease bearing of drive pinion
Check rope for wear acc. to DIN ISO 4309 and service
Check fastening bolts for secure seating
Check all parts of the winch and crank for wear, if ap-
plicable, replace defective parts and lubricate.
Check type plate for legibility
Have an inspection performed by an expert
Lubricant recommendations: Multi-purpose grease per DIN 51502 K3K-20

12. spAre pArTs

When ordering spare parts it is e s s e n t i a l to quote:
– The type and serial number of the equipment / item and part number

13. DIsAssemBLY, DIsposAL

– Make sure to observe the safety instructions.
– Dispose of the equipment and the substances within it in an environ-
mentally responsible manner.
Intervals
Before
every use
Quarterly
Annually
Annually
2