Kress KG160E.9 Bedienungsanleitung Seite 14

TROUBLESHOOTING
The following table gives problems and actions that
you can perform if your machine does not operate
correctly.
Warning: Switch the machine off and
remove the battery prior to any
troubleshooting.
Problems
Trimmer fails Battery
to operate. discharged.
Battery too
hot/cold.
Motor is
broken.
Internal wiring
of machine
damaged.
Trimmer runs Motor is
intermittently broken.
Battery not
fully charged.
On/Off switch
defective.
14
Excessive Machine
EN
vibrations/ defective.
noise. Line spool is
not wound
well.
Cutting time Battery has
per battery not been
charge too used for long
short. period or only
charged for
short term.
Grass too
high.
Battery
defective.
Machine Line broken.
does not cut. Battery not
fully charged.
Motor is
broken (speed
is too low).
Grass
entangled
around cutting
head.
Possible Corrective
Causes Action
Recharge battery;
also see
the content in
charger manual.
Allow to cool/
warm.
Contact Service
Agent.
Contact Service
Agent.
Contact Service
Agent.
Recharge battery.
Contact Service
Agent.
Contact Service
Agent.
Rewind the
line. See '' To fit
spool and line
assembly.''
Fully charge
battery; also see
the content in
charger manual.
Cut in stages.
Replace the
battery.
Replace the line.
Recharge battery;
also see the
content in charger
manual
Contact Service
Agent.
Remove grass.
Continuous Battery not
lighting of (properly)
the battery inserted.
charge
indicator. Battery
No charging contacts
procedure contaminated.
possible.
Battery
defective.
Battery Plug of
charge battery
indicator charger not
does not plugged in
light up. (properly).
Socket outlet,
mains cable
or battery
charger
defective.
Machine The line is
does not cut. tangled on the
spool.
Properly insert
battery into
battery charger.
Clean the
battery contacts
or replace the
battery.
Replace the
battery.
Insert mains plug
(fully) into the
socket outlet.
Check the mains
voltage; have the
battery charger
checked by an
authorized after-
sales service
agent.
Wind all the line
in manually, open
the spool cap,
remove the line
from the spool
and rewind.