Environmental Protection - Kress KG160E.9 Bedienungsanleitung

Bump-line feed system (See Fig. H)
The trimmer is equipped with a bump-line system.
Just bump the trimmer head while the machine is
running, new line will feed out.
Using a backpack harness (See Fig. I1, I2, I3)
1.Insert the battery pack into the backpack harness.
2.Insert the battery adaptor into the trimmer.
3.Connect the backpack harness to your trimmer
with the connecting cord.
More details can be found in backpack harness's
manual.
Cutting Tips
1.Move the trimmer from left to right across the area
to be cut; it is less effective when moving from right
to left.
2.Use the tip of the cutting line to do trimming; do
not force the trimmer head into uncut grass.
3.Wire and picket fences may cause extra cutting
line wear and breakage. Stone and brick walls,
curbs, and wood may wear cutting line rapidly.
4.Avoid trees and shrubs. Tree bark, wood moldings,
siding, and fence posts can easily be damaged by
the cutting line.
AFTER OPERATION:
Assembling/Removing the trimmer head (See
Fig. J)
1.Insert the hex key into the hole and rotate the
trimmer head until it stops in a locked position.
2.Then, rotate clockwise to remove it, and
counterclockwise to assemble it.
Winding the line (See Fig. K1, K2)
1.Insert the replacement line through the eyelet and
feed it through the other side.
2.Ensure both ends of the line are even on each end
of the trimmer head (recommended 2m) and cut the
line.
3.Turn the dial clockwise to wind the line around the
spool until about 19cm remains on either side.
Replace the spool (See Fig. L1, L2, L3, L4)
1.Take off the cap and remove the old spool.
2.Put the empty spool in and take on the cap to wind
new line in.
Transporting
1.When transporting your trimmer by hand, hold the
middle of shaft to make sure that your machine is
parallel to the ground.
2.When transporting your trimmer in a vehicle,
secure and position it to prevent turnover or damage.
Storing
1.Remove the battery pack from the trimmer before
storage.
2.Store the trimmer in a dry and secure place that
is inaccessible to children and other unauthorized
people.
Cleaning
1.Do not use aggressive detergents or solvents.
Clean the machine after use with a moist cloth
dipped in neutral detergent.
2.Keep the socket free of foreign matters, and clean
with a soft and dry brush or cloth.
3.Do not spray water onto the motor and electrical
components.
4.Do not use pressure washer to clean your
machine.
MAINTENANCE
Always remove the battery pack from
your trimmer after use.
Always check the product prior to being
used for any damage.
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in
a dry room temperature location. Keep the motor
ventilation slots clean. Keep all working controls
free of dust.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
13
EN