Process; Completing Assembly; Operation; Adjusting The Table Top Height - Swedstyle Memory S Handbuch

8 Swedstyle Memory S - EN
4.1

Process

1. Choose whether you want to mount the hand control fixed or with a sliding function
34
2. Position the hand control under the table top and mark the position of the mounting points.
3. Use the screwdriver and 2 mounting screws to attach the hand control to the table top.
FIXED
28
NOTICE
The required tightening torque depends on the material of the table top. Do not exceed 2 Nm.
4.2

Completing assembly

After the Swedstyle Memory is attached to the table top, you must connect the cable
to the control box.
5

OPERATION

CAUTION. Risk of minor or moderate injury through uncontrolled movement
The table may not always stop exactly at the expected position. Failure to anticipate the table's
movements may lead to minor or moderate injury through crushing.
• Wait until the system has completely stopped before attempting to use the table
CAUTION. Risk of minor or moderate injury through unsecured objects
While the table moves up and down, unsecured objects may fall off the table and onto body
parts. This may lead to minor or moderate injury through crushing.
• Ensure loose objects are kept away from the edge of the table
• Do not leave unnecessary objects on the table during movement
SLIDING FUNCTION
34
28
CAUTION. Risk of minor or moderate injury through crushing
Failure to release keys of the hand control correctly may result in the table failing to stop
properly. This may lead to minor or moderate injury through crushing.
• Do not slide your finger to a different hand control key while another button is pressed
• Disconnect the system immediately if any key of the hand control becomes stuck
• Fingers may be crushed when you attempt to change the height of the table
• Ensure that no persons or objects are in the table's range of motion
INFO. The technology within the hand control may be interrupted by external interferences
during operation. This may lead to certain user inputs (i.e. button presses) not being recognized.
This section of the operating manual contains a selection of instructions for operating the table
system to which the hand control is connected. Hand control keys are represented as follows:
UP Key
DOWN Key
S
SAVE Key
Memory Position Key 1
Memory Position Key 2
Memory Position Key 3
Memory Position Key 4

5.1 Adjusting the table top height

INFO The table top will move up or down until the UP or DOWN Key is released,
or if a pre-defined stopping point has been reached.
To move the table top UP:
Press and hold until the desired height has been reached
To move the table top DOWN:
Press and hold until the desired height has been reached
Swedstyle Memory S - EN 9