Inhaltsverzeichnis
Werbung
Remote control car battery installation and charging instructions :
Open the remote control car battery cover, install 6V charging batteries set and close the batteries
cover, tighten the screws.
Car power
Battery port
supply port
1. Connection：LED light lit;
2. Charging： LED light flash slowly;
3. Charging Completed：
LED light goes out;
This product uses 2.4GHz frequency remote control, before the play,the frequency between remote control
and the vehicle should be paired:
After installed the batteries, the rc car and remote control power are turned on.
RC car power switch
At this point the remote control will automatically find the frequency, light is blinking.
When the remote control light stops flashing. Frequency matching is completed,the remote control function
can be used normaly.
6V BATTERY SET
Intelligent USB Charging Cable
(Including)
6V BATTERY SET
(Including)
Frequency Pairing:
SWITCH
Remote Control Power Switch
- 1 -
Mode 1
Connect to the computer
USB charging
Mode 2
Connect to the
USB adapter charge
Mode 3
Connect to a mobile
charging treasure
Werbung
Inhaltsverzeichnis
