Speed Preselection - Bosch GWX Professional 14-125 S Originalbetriebsanleitung

26 | English
Kickback control
If there is a sudden kickback in the power tool,
e.g. jamming in a separating cut, the power
supply to the motor will be interrupted elec-
tronically.
To restart the tool, set the On/Off switch (4) to the "off" po-
sition and then switch the power tool on again.
X-LOCK run-out brake
(GWX 17-125 PSB)
The power tool is fitted with an electronic run-
out brake. When the power supply to the
power tool is switched off or interrupted, the
abrasive tool is brought to a complete stop

Speed preselection

You can preselect the required speed using the speed preselection thumbwheel (6), even during operation, provided the dust
filter (5) is not fitted. Otherwise remove the dust filter (5) beforehand. The information in the table below describes the re-
commended values.
Material Application
Metal Removing paint
Metal Brushing, removing rust
Stainless steel Grinding
Metal Rough grinding
Metal Cutting
Stone Cutting
The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated speed
can break and fly apart.
Speed preselection level
1
2
3
4
5
6
The values specified for speed levels are guide values.
Fitting
Fitting Protective Equipment
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Note: If the grinding disc breaks during operation or the
holding fixtures on the protective guard/power tool become
damaged, the power tool must be sent to the after-sales ser-
vice immediately; see the "After-Sales Service and Applica-
tion Service" section for addresses.
1 609 92A 6A2 | (10.10.2022)
within a few seconds.When Drop Control or Kickback Con-
trol are triggered, the power tool will brake even faster than
this.
Drop control
(GWX 17-125 PSB)
DROP
CONTROL
Application tool
Sanding sheet
Cup brush, abrasive disc
Grinding disc/fibre disc
Grinding disc
Cutting disc
Diamond cutting disc
Protective guard for grinding
-1
[min ]
2800
4500
6200
7900
9600
11,500
Adjust the position of the protective guard (11) to meet the
requirements of the operation. To do this, push the unlock-
ing lever (1) upward and rotate the protective guard (11)
into the required position.
Always position the protective guard (11) such that
u
the two cams on the unlocking lever (1) engage in the
corresponding openings on the protective guard (11).
Adjust the protective guard (11) such that sparking in
u
the direction of the operator is prevented.
The protective guard (11) must only be adjustable
u
while the unlocking lever (1) is actuated. Otherwise,
The integrated impact shutdown switches the
power tool off as soon as it hits the floor.
Thumbwheel position
2–3
3
4–6
6
6
6
Place the protective guard
(11) onto the holder on the
power tool until the coding
cams of the protective guard
are aligned with the holder.
When doing so, press and
hold the unlocking lever (1).
Press the protective guard
(11) onto the spindle collar
until the shoulder of the pro-
tective guard is sitting on the
flange of the power tool and
rotate the protective guard
until it audibly clicks into
place.
Bosch Power Tools