Navkom Touchpad Bedienungsanleitung Seite 12

CONNECTION TO THE KEYPAD (APPLE)
Every new keypad needs to be added in the x-manager
application, before it can be used. If more than one
device is connected to a single x-manager application, it
is important that the first connection is established with
one device at a time. The rest of the devices should not
be connected to a power supply at the time of the first
connection.
1
Press ADD and then START.
2
Confirm the connection by pressing Join.
3
Enter the desired device name and press SETUP.
1
4
5
22
EN EN
CONNECTION TO THE KEYPAD WITH AN
ADDITIONAL DEVICE
(APPLE)
A SINGLE KEYPAD CAN BE CONNECTED TO MORE THAN ONE DEVICE
(X-MANAGER APP).
If we are adding an additional device, it is
necessary to turn off WiFi on already
added devices, if these are nearby, otherwise
they will try to connect and disable adding of
an additional device.
On the phone that the keypad is already connected to,
press the i icon next to the keypad name.
Two options appear on the screen:
4
2
QR CODE which you
Press Scan QR code
can scan using the
on the new phone
new phone
5
Show password:
the PASSWORD is
Press Manual setup
displayed, which you
on the new phone
can enter manually in
the new phone
DISCONNECTING THE KEYPAD (APPLE)
Press the i next to the name of the keypad and then
confirm by pressing DELETE.
3
UNLOCKING THE DOOR WITH THE APP
The user or administrator can unlock/open the door with
the APP.
By clicking on the field "Touch to open" the
1
door will unlock.
1
LED SETTINGS
LED SETTINGS: If there is an additional LED
lighting in the door, it can be connected to the
system and controlled by the X-manager (only
with door leaf control unit). It is possible to adjust
2
2
the brightness (1% to 100%) and the schedule for
turning the lighting on/off. If the checkbox next
to the 24h is checked, the LED will be switched on
continuously.
RESET THE DEVICE WITH THE APP
3
By clicking on the field »System« and then
"FACTORY RESET" all codes stored in the mem-
ory, including administrator code, will be erased
and the device will be reset to factory settings.
3
Connection with the mobile phones/devices will
be lost.
After this operation, mobile phone must be paired
first.
23
EN EN