Troubleshooting; Cleaning Of The Product - SACKit Go 200 Gebrauchsanleitung

TROUBLESHOOTING

If you have trouble operating SACKit Go 200, please search the following options for solving the problem.
If these solutions do not help fix your problem, please contact our customer service at info@sackit.dk.
No sound from my SACKit Go 200
• Try to increase the volume on your Bluetooth device .
My SACKit Go 200 make static noise
• If you are using a Bluetooth connection, then please make sure that the speaker and your Bluetooth
device is within 10 meters of each other .
Bluetooth connection failed
• Please make sure, that SACKit Go 200 is in correct Bluetooth pairing mode .
• Check if your SACKit Go 200 is already connected to another Bluetooth device . SACKit Go 200 can
only be connected to one device at a time.
• Please make sure, that the speaker and your Bluetooth device is within 10 meters of each other .
• Please make sure, that there is no obstructions between the speaker and your Bluetooth device.
I cannot turn on/charge my SACKit Go 200
• Please make sure that the adapter and the charging cable is connected correctly .
• Please check the power adapters voltage and current and check if it matches with the requirements
of the SACKit Go 200 .

CLEANING OF THE PRODUCT

1 . Please turn off SACKit Go 200 and remove it from the power supply before you clean it
2 . Do not use any strong chemicals to clean the product as this may damage the surface or fabric .
3 . Please use a damp cotton- or microfiber cleaning cloth instead.
4 . During cleaning please be aware to avoid water in the USB port or other openings . Large amounts
of water and fluids may damage the SACKit Go 200.
NOTE: Avoid using sharp objects while cleaning the SACKit Go 200 .
6