The Device; Getting Started; Battery Information - SACKit Go 200 Gebrauchsanleitung

THE DEVICE

Getting started

Follow these simple steps to get started:
1 . Charge SACKit Go 200 in the USB-C port (B) with the included USB-C charger cable .
2 . Turn on SACKit Go 200 by holding down the Power button (A).
How to use Bluetooth
1 . SACKit Go 200 automatically enters Bluetooth mode when it is turned on. If no device has been
paired with the speaker before, the SACKit Go 200 is waiting for a new connection.
2 . Go to the Bluetooth settings on your device and make sure Bluetooth is turned on.
3 . Look for "SACKit Go 200" in the list of bluetooth devices .
4 . When it appears, tap the name to pair. The speaker emmits a confirmation voice saying: "Connected"
as soon as it is paired .
5 . Your device is now connected to SACKit Go 200 and you can enjoy your music .
To connect to a new device make sure that the previous connected device is disconnected otherwise
connecting opportunities will not appear on the new device.
Disconnect Bluetooth
1 . To disconnect the Bluetooth connection to a device, double press the the Power button (A).
SACKit Go 200 will play the sound
2 . SACKit Go 200 is now disconnected and is searching for a new device to pair .

Battery information

• Battery: rechargeable litium batteri 950mAh
• Power input: DC5V/1A
• Charging Time: Please be sure the battery has been fully charged before first use. It can take up to
3 hours of charging the first time, but 2 hours normally with a 5V/1A adapter.
TRUE WIRELESS STEREO MODE
Use two SACKit Go 200 together
1 . Make sure you have two Go 200 speakers in hand and turn on both speakers . If you are already
connected to the devices, please unpair the speakers in the Bluetooth settings on your device.
2 . When the speakers are disconnected and the LED's are blinking white, quickly press the
button (A) twice on both speakers to enter TWS pairing mode . One speaker becomes the master
speaker, the other the slave. (The LED flashes green on the master and the LED is solid green on
the slave) .
3 . After TWS pairing between the speakers is successful, the master speaker says "Left channel" and
the slave speaker says "Right channel" .
4 . Find the speakers in your device's Bluetooth settings and connect to them. Both LED's will now
display a solid green . You are now ready to play your music .
5 . To disable TWS unpair the the speakers in Bluetooth setting on your device. One of the speakers
LED will blink green . Double press the blinking LED and the speakers will go back to normal pairing .
"Disconnected" .
Power
5