Manually Pairing The Headset And Wireless Adapter - HyperX Cloud Stinger 2 Wireless Anleitung

Manually Pairing the Headset and Wireless Adapter

The headset and wireless adapter are automatically paired together out of the box. But if manual
pairing is needed, follow the steps below to pair the headset and wireless adapter.
1. While the headset is off, hold the power button until the headset status LED starts blinking
red/green rapidly.
2. While the wireless adapter is plugged in, use a small tool (e.g. paper clip, SIM tray ejector, etc.)
to press the button inside the pin hole until the adapter LED starts blinking rapidly.
3. Wait until both the headset LED and the USB adapter LED are solid. The
headset and wireless adapter are now paired together.
Questions or Setup Issues?
Contact the HyperX support team at: hyperx.com/support
Document No. 676A2AA.A01 HyperX Cloud Stinger 2 Wireless Page 17 of 17