Herunterladen Inhalt Inhalt Diese Seite drucken

Walimex Pro Rainbow RGB Stick 18W Gebrauchsanleitung Seite 21

Led leuchtstab
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING
Risk of electric shock, risk of burns
Note that the unit is still connected to the mains voltage even when it is switched off.
Only when you disconnect the unit from the power supply by pulling the mains plug is it
really voltage-free.
■ Switch the unit off when you are not using it.
■ Switch off the unit before all assembly and maintenance work and disconnect the power
supply by pulling out the mains plug.
■ Secure the unit against unintentional switch-on.
■ Interrupt the power supply during longer breaks in operation by pulling out the mains plug.
NOTICE
Compare local power supply with the connection values of the unit.
If the values do not match, please contact info@walser.de.
WARNING
Electric shock hazard and fire hazard, caused by a short circuit
A short circuit can be caused, among other things, by defective cables and by moisture
or wetness. In the event of a short circuit, the line wires can heat up so much that their
insulation melts or the line wires even melt through. This can cause a fire.
■ Only use the original cables supplied for the unit. Only these cables are matched to
the unit and guarantee the necessary safety for you and your unit.
■ Do not operate the unit with wet hands or feet.
■ Operate the appliance only in dry rooms.
■ Do not operate the unit outdoors.
■ Only clean the unit in the manner specified in these instructions for use.
■ Make sure that cables and wires are not damaged. This could
be the case, for example, due to the effects of heat, chemical influences or mechanical
influences such as rubbing, bending, tugging, rolling over or nibbling pets.
■ Make sure that the unit does not fall down. If the unit has fallen down, have it checked
by a qualified electrician before switching it on again.
■ If the unit is damaged or defective or if you notice a smell of burning:
Immediately interrupt the power supply by pulling out the mains plug. Do not
operate the unit with a damaged housing, defective modelling lamp, defective flash
tube or damaged mains cable. Do not open the unit. Never repair the unit yourself.
Only have the unit repaired by a qualified electrician.
■ Always maintain the unit in accordance with the instructions in this manual.
■ Only use spare parts for this unit that comply with the prescribed specification.
■ Lamps may only be replaced by a qualified electrician.
20

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis