Mennekes AMAXX Montage- Und Betriebsanleitung Seite 15

Operation
1
2
IMPORTANT!
As an alternative, mounting from the inside below the
housing screws is also possible.
Choose the fuse and cable cross section according to the
receptacle combination variant: see nameplate.
Select a cable fi tting suitable for the degree of protection
needed for the receptacle combination.
IMPORTANT!
You can unlock and move the top hat rails.
Tip: Tighten the housing screws with 2 nm.
Additional installation tip:
This article was designed by MENNEKES for stationary use.
MENNEKES is not liable for non designated use!
The correct position of use in compliance with IP 44 require-
ments pertaining to spray water protection is defi ned by the
opening direction of the hinged lid, which opens upwards.
Positions of use not in accord to the information listed on the
device will result in a limited degree of protection.
This is to be taken into consideration especially for outdoor use.
If condensation is expected in receptacle combinations, with
IP 44 protection, the condensation hole in the lower housing area
should be opened. See page 6, point 4, of the overview.
WARNING! Electrical current!
The window has a latch-lock. Always leave the window
closed during operation.
Click the window into place to achieve protection degree IP 44.
To achieve protection degree IP 67, tighten both thumb screws (1)
on the window as well.
NOTE!
The window can be locked at the eyelet using a padlock.
WARNING! Electrical current!
Plug devices with protection degree IP 67 have a
bayonet system. Turn the bayonet rings (2) until
tightly closed to achieve protection degree IP 67.
15