Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
POWER SUPPLY
The short-circuit protection on the output is not effective when set as power
supply!
If the charger is in its power supply function, the three charge status LED's are
used to indicate the height of the load. This way you know how much power the
charger supplies.
LED
Green, flashes
Green
Green + orange
Yellow
I N S T A L L A T I O N
Make sure that the charger is voltage free during installation.
The atmosphere
The battery should be charged in an area with adequate ventilation because it
may emit explosive gases. Be sure that there is enough space around the
charger (ventilation openings must not be blocked). This is important for the air
circulation, for cooling of the charger and release of gases emitted. Protect the
charger from direct hard water jets.
Important
Don't not charge when there is a fuel leak or fuel is evaporating.
Mounting
The charger can be mounted in different ways with the mounting plate on the
bottem of the charger. Place the charger on a stabile underground.
With the optional mounting clamp PC1 the charger can be easy
placed en taken, without removing the screws each time.
Connection with the battery
Due to the automatic voltage compensation we strongly recommend to leave the
cable length as it is. However, if you want to shorten the cable, it is important
that the length doesn't become less than 1 meter. The cable length can be
extended, but that will also have effect on the automatic voltage compensation.
21
13,5V / 27,0V
Current
0%
1% - 20%
21% - 40%
41% - 60%
LED
Orange + red
Red
Red, flashes
1 2 3 4
Current
61% - 80%
81% - 100%
> 100%
Werbung
