Installation Instructions - Sunwood Marino Gebrauchsanleitung

INSTALLATION INSTRUCTIONS

FOLLOW THESE STEPS WITH THE ILLUSTRATIONS AT THE BACK
Attention: When you need help to install the fire place, please contact your dealer.
STEP 1
Attach the wheels if desired. The correct
mounting order seen from below is: Bolt –
Wheel – Marino – Washer – Spring washer –
Nut. Use the included wrench to tighten.
STEP 3
Assemble the top of the Marino with the
supplied screws. Use a phillips screwdriver to
do this (not included in delivery).
STEP 5
Always leave the gas cylinder standing up. Do
not let the hose contact any sharp objects
or edges which may damage the hose.
WARNING
Check the hose at least once a month and every time you change the gas cylinder. If
the hose contains any damage, it will need to be changed by a hose of the same length
and quality.
STEP 2
Place the lava stones equally over the burner
and the surrounding frame. While doing this
make sure that as little dust as possible will
get into the burner.
STEP 4
Mount the pressure regulator on the gas
cylinder with a good fitting wrench. Tighten it
firmly. Failing to do so will result in leakage
and possibly dangerous situations. Only
change the gas cylinder in a well ventilated
space and out of sight of candles, cigarettes,
and other flammable products.
STEP 6
Check all the connections on signs of leakage.
You can do this by using soap or a gas leaking
spray on the gas fittings/connections. If you
notice any air bubbles then there is a leak.
EN
11