How To Use Ehelp; Faqs - Panasonic TX-40JX850E Bedienungsanleitung

How to Use eHELP

[eHELP] is the detailed operating instructions built into
the TV, and gives a more detailed explanation for a
better understanding of the operation of each feature.
1
Display [eHELP]
or
[Main Menu]
If the [eHELP] has been accessed previously since
the TV was turned on, the confirmation screen is
displayed to select whether to go to the [First page] or
to the [Last viewed page].
2
Select the menu
select
access
To access [How to use]
(green)
3
Select the item
Example:
select
access
To return to the previous screen / field
24
English
[Help] [eHELP]

FAQs

Before requesting service or assistance, please follow
these simple guides to solve the problem.
For details, refer to [eHELP] (Support > FAQs).
The TV does not switch on
Check the mains lead is plugged into the TV and the
mains socket.
The TV goes into Standby mode
Auto power standby function is activated.
The remote control does not work or is intermittent
Are the batteries installed correctly?
Has the TV been switched on?
The batteries may be running low. Replace them with
new ones.
Point the remote control directly at the TV's remote
control signal receiver (within about 7 m and a
30 degree angle of the signal receiver).*
Situate the TV away from sunshine or other sources
of bright light so they do not shine on the TV's remote
control signal receiver.*
Is the remote control mode wrong?
If you are trying to use voice controls, is the remote
control registered (paired) with the TV?
When infrared communication is used
No image is displayed
Check the TV is turned on.
Check the mains lead is plugged into the TV and the
mains socket.
Check the correct input mode is selected.
Is [Backlight], [Contrast], [Brightness] or [Colour] in
the Picture menu set to the minimum?
Check all required cables and connections are firmly
in place.
An unusual image is displayed
This TV has a built-in Self Test. Makes a diagnosis of
picture or sound problems.
[TV Self Test] ([Help] menu)
Turn the TV off with Mains power On / Off switch,
then turn it on again.
If the problem persists, initialise all settings.
[Shipping Condition] in [System Menu] ([Setup]
menu)
(p. 20)
(p. 20)
(p. 18)