Watching Tv - Panasonic TX-40JX850E Bedienungsanleitung

Set up the network connection
Depending on the country you select, select your
Region or store the Child Lock-PIN number ("0000"
cannot be stored).
Tick the TV signal mode to tune, and then select
[Start Auto Setup]
Auto Setup screen varies depending on the country
and the signal mode you select.
[DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
Auto Setup is now complete and the
TV is ready for viewing.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the
on-screen instructions.
Note
The TV goes into Standby mode when no operation
is performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).
The TV goes into Standby mode when no signal is
received and no operation is performed for
10 minutes if [No signal Power off] in the Timer menu
is set to [On] (factory setting).
To retune all channels
[Auto Setup] in [Tuning Menu] ([Setup] menu)
To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] ([Setup]
menu)
To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)

Watching TV

1
Turn power on
(TV)
or
(Remote Control)
Mains power On / Off switch should be on.
(p. 22)
2
Select the mode
TV Selection
DVB-S
DVB-C
DVB-T
DVB-via-IP
Analogue
Selectable modes vary depending on the channels
stored.
3
Select a channel
up
down
or
To select a channel position with 2 or more-digit, e.g.
399
23
English