Panasonic TX-40JX850E Bedienungsanleitung Seite 20

20 Rakuten TV
Accesses Rakuten TV service directly.
21 YouTube
Accesses YouTube service directly.
22 APPS
Displays [Apps] (applications list).
23 TV Guide
Displays Electronic Programme Guide.
24 EXIT
Returns to the normal viewing screen.
25 Cursor buttons
Makes selections and adjustments.
26 BACK
Returns to the previous menu / page.
27 SCENERY
Displays the currently selected scenery.
For details, refer to [eHELP] (Search by Purpose >
Home > My Scenery).
28 Operations for contents, connected equipment,
etc.
29 Teletext button
30 Channel Up / Down
31 Subtitles
Displays subtitles.
32 Last view
Switches to previously viewed channel or input
mode.
Installing / Removing batteries
Slide and lift
Note the correct polarity (+ or -)
Close
20
English
Remote Control Mode setting
If another Panasonic TV is near the TV, the other TV
may be operated when you use the remote control with
infrared. Change the TV's remote control mode to avoid
simultaneous operation.
Remote control mode 1 is the default setting.
1
Display the menu bar and select [Main Menu], and
then select [Setup]
Main Menu
select
access
2
Select the remote control setting menu in [System
Menu]
select
access
3
Select the remote control mode in [Mode Setting]
select
access
4
Select [Mode2]
select
access
Press and hold [OK]/[MUTE]/[2]* (numeric buttons)
buttons for at least 3 seconds, then press the OK
button.
To set to [Mode1], set to "1", to set to [Mode3], set
to "3", to set to [Mode4], set to "4".
When using the remote control mode 1, set the TV
and the remote control to mode 1 respectively.
Remote Control Mode Error
When the TV receives a signal with a different remote
control mode to the mode that is set on the TV five
times, Remote Control Mode Error is displayed.
Follow the on-screen instructions.
When all settings are initialised by performing [Shipping
Condition], the TV's remote control mode is reset to
mode 1. If you cannot operate the TV with your remote
control, press and hold [OK]/[MUTE]/[1] buttons for at
least 3 seconds to set the remote control to mode 1.
Setup