Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.
Overview
Refer to the illustrations on page 2 of this manual.
camera
1
lens
2
IR LEDs
3
light sensor
power supply
A
on/off switch
B
power LED (green)
C
mains connector
hardware setup
1
monitor connection
2
to camera
6.
Installation
Refer to the illustrations on page 2 of this manual.
1.
Choose a location for the camera, keeping the following guidelines in mind:
Do not install the camera in locations where extremely high or low temperatures or excessive
o
vibrations may occur.
Avoid mounting the camera near strong electromagnetic fields.
o
Do not aim the camera at the sun or other extremely bright objects.
o
Do not install behind a glass (or other) window as this will impact image quality.
o
2.
Mount the mounting bracket [7] on a wall or ceiling with the 3 included screws.
3.
Screw the camera on the bracket with the camera connection screw [5]. Note that the camera has
two mounting holes on either side, for wall or ceiling mounting.
4.
Point the camera towards the field of interest and secure it by turning the butterfly nut [6].
5.
The other side of the RG58U cable must be connected to connector [F] of the coaxial power supply.
6.
Connect a monitor (not incl.) to connector [G] (cable not incl.).
7.
Plug the mains connector [C] in the mains (230 V / 50 Hz).
8.
Switch on the coaxial power supply with switch [A]. The status LED [B] turns green.
9.
In case of a blown fuse [D] in the power supply, replace it with a 250V/2A fuse.
7.
Adjusting Zoom and Focus
Refer to the illustrations on page 3 of this manual.
1.
Locate the hex head screw at the bottom of the camera (see arrow).
2.
Release this screw with the included Allen wrench and slide the housing towards the front of the
camera. The focus [a] and zoom [b] magnets become visible.
3.
First adjust the zoom magnet [b]. Slide it upwards to zoom in (longer distance, smaller viewing
angle); slide it downwards to zoom out (shorter distance, wider viewing angle).
4.
Then adjust the focus magnet [a]. Slide it upwards or downwards to adjust focus and make the
images sharper.
5.
Slide the housing back in place and secure it with the hex head screw. Do not apply excessive force
on the screw.
8.
Adjusting current settings
Refer to the illustrations on page 3 of this manual.
You can adjust the power setting of the current between the power supply and the camera.
Use the dip switches [E] on the back of the power supply to adjust the current.
Possible settings are: 100 mA – 200 mA – 280 mA – 340 mA - 450 mA.
The corresponding dip switch settings are as follows:
V. 02 – 27/06/2013
CAMCOLBUL24N
4
sunshield
5
camera bolt
6
position bolt
7
bracket
D
fuse
E
power adjustment switches
F
camera connector
G
monitor connector
3
to monitor
4
AC power cord
5
coaxial power supply
5
©Velleman nv
Werbung
Inhaltsverzeichnis
