Clearaudio basic V2 Bedienungsanleitung Seite 7

User manual / Bedienungsanleitung
3. Troubleshooting
If you have a problem with your basic V2 , first check the possible causes to rule out incorrect
operation.
If the error persists, please contact your dealer!
Never try to open the device and/ or repair it yourself, this w ill void the w arranty!
Error
Device does not w ork
No sound or
low volume?
Hum or
noise
One channel quieter or
louder
Made in Germany
Cause
Is the power cord plugged in and the power
switch turned on?
Did you choose the right input?
Have you selected the correct operating
mode?
Is the device in „mute" mode or is the
volume set too low?
The connection cables are not properly
connected.
Devices with a headphone output only:
Are the headphones still plugged in when
you are trying to play music through the
speakers?
The ground cable is not connected or is
faulty.
The device should not be operated in the
vicinity of high-frequency devices such as
mobile phones or modems or on power
supply systems used for data traffic (PLC).
The channels of an input are set differently.
Measure
Check the connection.
Check the connections of your hifi
components.
Check the settings on the underside of the
phono stage.
Check the volume setting of your device.
Check the tonearm
connections due the their respective user
manual.
Disconnect the headphones.
Connect the grounding cable from the
turntable/ tonearm to
grounding connection on the back of
the device. If there are several ground
connections, interrupt them one after the
other and check the sound quality again.
Make sure there is a minimum distance of
30cm between the power supply units of
any type and the MC preamplifier or phono
preamplifier. Powerlan adapters should not
be operated on the same socket as the
phono preamplifier.
Check the settings on the underside of the
phono stage. These must be carried out
identically for an input.
and cartridge
the respective
Page / Seite 7