Cleaning, Maintenance And Repair; Making The Portable Power Supply Ready For Use; Charging The Portable Power Supply, And Leds - Stihl PS 3000.0 Gebrauchsanleitung

English
► The portable power supply must not be
stored outside the specified temperature
limits, 15.3
■ The charging cable is not intended to be used
for carrying or hanging the portable power
supply from. The charging cable and the port‐
able power supply may become damaged.
► Wind the charging cable as a loop and
secure it.
4.10 Cleaning, maintenance and
repair
WARNING
■ Using harsh detergents, and cleaning with a
water jet or sharp objects can damage the
portable power supply. If the portable power
supply is not properly cleaned, parts may no
longer function correctly and safety devices
may be disabled. This may cause serious
injury to persons.
► Clean the portable power supply as descri‐
bed in this user manual.
■ If the portable power supply is not properly
maintained or repaired, components may no
longer function correctly, and safety devices
may be disabled. There is a risk of serious or
fatal injury.
► Do not maintain or repair the portable
power supply yourself.
► If the portable power supply requires main‐
tenance or repair, contact a STIHL servic‐
ing dealer.
5 Making the portable power
supply ready for use
5.1 Making the portable power sup‐
ply ready for use
The following steps must be performed before
commencing work:
► Check LEDs,
7.1
► Fully charge the portable power supply,
6.1.
► Clean the portable power supply,
► Ensure that the portable power supply condi‐
tion is safe, 4.5.
► If these steps cannot be carried out, do not
use the portable power supply and consult a
STIHL servicing dealer.
18

5 Making the portable power supply ready for use

6
6.1
The charging time depends on several factors,
e.g. the temperature of the portable power sup‐
ply and the ambient temperature. For optimum
performance, observe the recommended temper‐
ature ranges,
may vary from the charging time indicated. The
charging time is indicated at www.stihl.com/
charging-times.
The portable power supply heats up during
charging.
1
2
3
4
► Turn the rotary switch (1) to the
The charging input is activated.
► Open the cover (4).
► Insert the charger plug (3) into the charger
socket (2).
► Insert the mains plug (7) into a convenient
power outlet (8).
If the LEDs (5) light up green and the LED dis‐
play moves from left to right, the portable
power supply is being charged.
If the LEDs (5) light up green and the LED (5)
of the current state of charge is flashing green:
The portable power supply is too hot or too
cold. The charging starts automatically as
soon as the permitted temperature range is
reached. The charging time may take longer.
► Routing the charging cable (6).
12.1
► If all LEDs (5) light up green: The portable
power supply is fully charged.
► Turn the rotary switch (1) to the
► Remove the charging cable (6).
► Close the cover (4).
Charging the portable
power supply, and LEDs
Charging the portable power
supply
15.4. The actual charging time
8
7
6
5
position.
position.
0458-014-9901-A