Warranty And Repair - Hisense HCM20CS Gebrauchsanweisung

Cleaning mineral deposits
To keep your coffee maker operating efficiently, you should regularly clean away the mineral deposits left
by water, depending on the water quality in your area and the frequency use the appliance. Proceed as
follows:
1. Fill the water tank with water and descaling agent to the MAX level. The ratio of water to descaling
agent should be 4:1; for details, please refer to the instructions for use of the descaling agent. Please use
a "household descaling agent". You may also use citric acid instead of the descaling agent, in the ratio of
one hundred parts of water to three parts of citric acid.
2. Press down the power button, the red indicator will light up. Wait until the blue indicator turns on.
3. Position a container on the cup gate grid.
4. Press the coffee button and allow the liquid to flow for 1 minute. Then stop the flow by pressing the
coffee button again.
5. Wait for 20 minutes with the machine turned on.
6. Press the coffee button until all of the water is used up.
7. Rinse the tank thoroughly and fill it with clean water. Press the coffee button and hold it until all water is
used up.
Trouble shooting
Problem
No indication.
The machine makes a strange noise.
The lights are on but no coffee comes
out.
There is some water at the bottom of
machine.
A slight hiss can be heard after the
coffee has been released.
This equipment is labelled in compliance with the European Directive 2012/19/EC on waste
electric and electronic equipment
collection and management of waste electric and electronic equipment effective in the entire
ENVIRONMENT
At the end of the appliance's useful life, do not discard it with common household waste. Take is to an
authorized recycling centre. This will help preserve the environment.

WARRANTY AND REPAIR

For more information or in case of problems, please contact the Gorenje Call Centre in your country
(phone number listed in the International Warranty Sheet). If there is no such centre in your country,
please contact the local Gorenje dealer or Gorenje's small domestic appliance department.
For personal use only!
WISHES YOU A LOT OF PLEASURE IN USING YOUR APPLIANCE.
Solution
Check that the plug is correctly inserted into the socket,
that the power button has been pressed, and that the
corresponding red light is on.
Check whether there is water in the tank
The capsule inserted may be faulty. Wait for a few
seconds, then try again with a new capsule.
Make sure that the tank has been fitted correctly into
position.
This is not a fault, it is a normal settling of the pressure
control valve.
–
WEEE. The Directive specifies the requirements for
European Union.
HISENSE
25