Installing The Psk-Dc 1200 Skimmer Pump And Skim-Sensor - Red Sea PSK DC-1200 Benutzerhandbuch

Red Sea REEFER DC-Skimmer
TM
Installing the PSK DC-1200 Skimmer pump and Skim-sensor
Full instructions for installing the REEFER Skimmer are provided in the
REEFER Skimmer instruction manual.
The PSK DC-1200 skimmer pump is an exact drop-in replacement
for the PSK AC pumps. Follow the instructions in the REEFER Skimmer
manual to install the pump.
Skimmer pumps need to be cleaned on a
regular basis to remove calcium carbonate and
other deposits and therefore it is recommended
to familiarize yourself with the pump by
disassembling/reassembling it before installing
it for the first time in the skimmer. If you are
replacing an existing AC pump, remember to
return the cable restraint back into position.
Select a suitable location for the connector between the pump and
control cable to allow easy access when removing the pump for
maintenance.
Connect the control cable to the pump and power supply and thread the
controller part of the cable to the ReefRun Dual controller (RRDC).
The pump will not work until the RRDC has been onboarded to the
ReefBeat App and the pump has been setup.
10
Prepare the DC skimmer lid for use with the Skim-sensor by removing
the plastic plugs and inserting the black rubber grommets in the sensor
mounting holes. (Note; the wider flange of the grommets should be on
the upper surface of the lid.) The grommets are essential for holding the
sensor securely in position so ensure that they are in place.
If you have the upgrade kit you will need to replace the original lid with
a DC-Skimmer lid and transfer the neck wiper to the new lid.
A
C
B