Millarco BOXER Gebrauchsanweisung Seite 43

LISTENING MODE:
1. In any mode, press [LIS/Phone] more than 3 seconds to start listen.
2. Adjust the volume as need on earmuff by using the dial.
3. Press [LIS/Phone] again more than 3 seconds to end listen.
Note: Press to listen function will stop current Bluetooth/Radio if you start it,
after ending listen function, earmuff will go back to last Bluetooth/Radio mode.
AUX-IN MODE:
1. Power on the earmuff.
2. To use the Aux Input, plug a 3.5mm cable into the Aux-In port on earmuff.
3. Adjust the volume at your device.
4. Draw the cable out, the earmuff go to Bluetooth mode.
Notes:
1. It will stop current Bluetooth/Radio if you plug the cable.
2. It can be used at power off status too, the volume can be adjusted on your
device.
WARNING:
This ear-muff is provided with level-dependent attenuation. The wearer should
check correct operation before use. If distortion or failure is detected, the
wearer should refer to the manufacturers' advice for maintenance and
replacement of the battery. Warning-performance may deteriorate with battery
usage. The typical period of continuous use that can be expected from the
ear-muff battery is 15 hours. The output of the level-dependent circuits of this
hearing protector may exceed the external sound level. The ear muffs provides
electrical audio input.
43