Display And Control Elements; Intended Use - Niko 10-803 Produktinformation

3. OVERALL PICTURE OF THE DEVICE
Connection mains voltage

4. DISPLAY AND CONTROL ELEMENTS

Name
Programming key
LED for the operating mode (yellow)
LEDs circuit status (red)

5. INTENDED USE

• External unit connections 10-803 are intended solely to connect external units.
• They are suitable for installations with 1 circuit per 50 mA.
EN
Connection door
18 19 20 21 22
23
>6
20 21
12 V
24 V; 2A
1 3
230 V; 50-60 Hz; 0,35 A
1 2 3 4 5 6
Programming key
bus1 bus2
24 25 26 27 28 29 30
bus
Ader 1
P a b a b
23 24 25 26 27
10-803
PROG
10
MASTER
t 40°C
a SECONDARY
7 8 9 10 11
LED for
the operating mode
Function
Switch operating mode
Is on: operating mode MASTER.
Switched on and off (lights up with small interrup-tions): operating mode SECONDARY.
Flashing: Switching between operating modes.
There is one LED for each circuit.
Is on: The door call of the main external unit was confirmed by an internal unit on this
circuit. The internal unit was found on this circuit. Only one LED can be on.
bus3 bus4
31 32 33 34 35
bus bus
Ader 2 Ader 3 Ader 4
a b a b a
28 29 30 31 32
ADERSTATUS
12 14 15 16 17
1 2 3 4
12 13 14 16 17
15
LEDs circuit status
10-803
bus
b
33
P
A
31