Safety Instructions; Technical Data - Kayoba 008053 Bedienungsanleitung

SAFETY INSTRUCTIONS

• Read the instructions carefully before use.
Save them for future reference.
• The pump is intended for pumping
stationary fresh water or saltwater.
The user must accept responsibility for
any consequential damage if the pump
is used for liquid other than water.
• The pump is spark protected.
VARNING!
The pump cannot run dry for more than 10
seconds!
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
as electrical waste.

TECHNICAL DATA

Connection
Flow
Size
Voltage
Output
DESCRIPTION
1. Wire connection
2. Motor bracket
3. Oil seal
4. Impeller
5. Filter
6. Pump cover
7. Self-tapping screw
19 mm
43 L/min
108 x 70,4 x 90,7 mm
12 V
30 W
8. Motor
9. Gasket
10. Motor casing
FIG. 1
11. Pump
12. To outlet over water line
13. Screw
14. Filter base with snap fastener
15. Adapter
16. Switch
FIG. 2
INSTALLATION
INSTALLING THE PUMP
Decide where to put the pump. If only one pump
is used, put it where the water is deepest when
the boat is still. The pump should be installed
so that the hose can be fully emptied. The hose
should be routed horizontally or up, without
coiling or bends where water can collect.
1. Loosen the filter from the pump by pressing
in the tabs on the side of the pump.
2. Position the filter so that the outlet hose
can be connected at a suitable angle.
– If the filter is to be installed on wood,
fasten it with stainless screws.
– If the filter is to be installed on
fibreglass, first fit a piece of wood and
then fasten the filter on the wood.
3. Fit the pump on the filter by pressing it
on the two fasteners until it clicks. The
pump can be positioned in the required
direction on the fasteners.
IMPORTANT:
Never run the pump without the filter.
NOTE:
Pump will not be damaged if connected to
a hose with a smaller diameter. This will,
however, reduce the flow.
EN
19