First-Time Operation; Operation - LIVARNO home 1115-S Bedienungs- Und Sicherheitshinweise

z First-time operation
Charging the battery
The battery is charged in all operating
modes� To optimise initial charging, leave
the product switched off curing charging�
Please note: The battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours� The duration of the charging
process depends on the battery's charge
level and the quality of the sunlight�
Using the remote control
Please note: The batteries supplied are
already inserted into the product and fitted
with an isolator strip� Remove this strip to
start using the product�
z Operation
The product can be operated in three
different modes� The operating mode is
selected using the remote control
Please note: The solar panel will turn on
the product in twilight or darkness in the
mode you have set�
Please note: Battery charging via the solar
panel does not depend on which mode is
selected� The battery is charged continuously
at all times�
First, turn the product on by pressing the
„ „
ON/OFF button
7
Mode: Sensor mode
Press the "Sensor mode" button on the
„ „
remote control
10
If the motion sensor detects movement
„ „
within its range, the product will light up at
maximum brightness�
10
GB
�
10
�
(see fig. A).
If no further movement is detected after
„ „
approx� 30 seconds, the LEDs will switch
off�
Once the LEDs are off and the motion
„ „
sensor is in standby, the signal LED
flash red (see Fig. A).
You can also initiate sensor mode by
„ „
pressing the ON/OFF button
Mode: Flash
Press the "Flash" button on the remote
„ „
control �
10
The LEDs will flash for approx. 30 seconds.
„ „
"Sensor mode" is now activated (see
"Mode: Sensor mode")�
Mode: 75% brightness
Press the "75%" button on the remote
„ „
control �
10
The product will light up with low
„ „
brightness� The motion sensor is inactive in
this mode�
Switching the product off
You can switch the product off using the
„ „
remote control by pressing the ON/
10
OFF button �
7
Please note: You can still operate the
product using the remote control�
To do this, press the "Sensor mode" button�
„ „
You can also switch the product off using the
ON/OFF button�
will
9
�
7