nedis SCLU112BU Kurzanleitung Seite 7

Using the product (image B)
1. Press and hold power and Z/T button A
second to switch on the product.
2. When the display A
measurement unit button A
measurement unit.
3. Pass the belt A
4. Secure the hook A
A
.
2
5. Hold the product horizontally over the luggage.
6. Press power and Z/T button A
any weight that should not be included in the total
weight of luggage. The display A
letter T and resets to 0.00.
7. Lift the product and luggage gently off the floor.
8. Wait for the weight reading to stop and stabilise.
The display A
measured weight 3 times and then locks.
9. The display A
minutes, then automatically switches off.
When the product is unable to read the weight of
4
the luggage, press power and Z/T button A
reset the display to 0.00 and try again.
10. Press and hold power and Z/T button A
seconds to switch off the product manually.
Do not keep the product around sharp edged
4
objects while in storage to avoid pressure on
buttons that causes unnecessary battery drainage.
Troubleshooting
Display
warning
messages
Lo
1 shows 0.00, press
5 through the luggage handle.
6 around the triangular ring
shows the letter H, flashes the
1
shows the measured weight for 2
1
Possible cause
Low battery
7
4 to select
to zero or tare
3
shows the
1
Possible
solution
Replace old
battery with
new battery.
3 for 1
to
3
3 for 3