Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
InstallatIon
2.
2.1. Connection
Important: Only connect the following connections when the SIP intercom is de-energised
(no POE supply connected)
Connect the Behnke IP camera to the RJ45 plug of the USB to LAN adapter. To do this, first remove the
network cable on the IP camera. If necessary, extend the LAN cable coming from the USB to LAN adapter
with the network cable and port extender (included in the scope of delivery of the Behnke IP camera)
(max. 1 m). In the next step, connect the 4-pin HPI connector (2) to the USB port of the SIP intercom.
Finally, connect the 2-pole HPI plug (3) to the USB extension port adapter +/- 12 volt= of the SIP intercom.
Please also refer to the installation example. Then put the microphone unit into operation (POE supply).
SIP-Basic electronic 3.0
www.behnke-online.com
Instructions Behnke adapter for USB camera/IP-intercom stations
2
3
Adapter
Intercom station
Front panel with built-in modules
and module housing (see also inst-
ructions for SIP basic electronics)
Installation
1
GB
13
Werbung
Inhaltsverzeichnis
