neno Lindo Bedienungsanleitung Seite 11

2. Press the power button to switch the unit on or off. When switched on, the
function indicators will illuminate on the screen.
3. Only pour distilled water into the appliance. The use of tap water can cause
large-scale accumulations.
4. Select one of the possible functions:
a. Quick heat: Pour in approximately 500 ml of water, then insert a bottle
or jar of food and replace the lid. Press the quick heat function button
and set the temperature between 35°C–40°C, the default temperature is
40°C. The appliance will start the accelerated heating mode. Once heated
to the set temperature, the heater will switch off but will continue to give
off heat, so the actual temperature may differ from the set temperature
by up to ~10°C. If you want a stable heating temperature, use the milk
heating function. Check the temperature of the warmed food before
giving it to your baby. Once warming is complete, press the power button
or quick warm again to put the unit into sleep mode or disconnect the
steriliser from the power supply.
b. Temperature maintenance: Pour between 300 and 500 ml of water,
then insert the bottle, pouch or jar of food and replace the lid. Press
the modified milk function button and set the temperature between
40°C–65°C, the default temperature is 45°C. When finished heating,
press the power button or reheat modified milk to put the unit into sleep
mode or disconnect the steriliser from the power supply.
c. Heating the milk: Pour in between 300 and 500 ml of water, then insert
a bottle, pouch or jar of breastmilk and replace the lid. Press the milk
warming function button and set the temperature between 35°C–45°C,
the default temperature is 40°C. When heating is complete, press the
power button or the milk reheat button to put the unit into sleep mode
or unplug the steriliser.
d. Defrosting: pour in between 300 and 500 ml of water, then insert a
bottle, pouch or jar of food and replace the lid. Press the defrost function
button and set the temperature between 25°C–40°C, the default tempe-
rature is 35°C. After 30 minutes, the appliance will go into a 40°C keep
warm state. If you want a constant temperature use the Milk Warm-up
mode. Once heating is complete, press the power button or the defrost
button again to put the unit into sleep mode or unplug the steriliser.
e. Sterilisation: Pour in the correct amount of water according to the selec-
ted programme, then place the bottles on the bottle holder and insert
them into the machine. SEE FIG B Press the disinfection function button
and select one of the three modes.
• Mode for plastic bottles, pour in 100–120 ml of water. Duration: 18
minutes, the machine heats the water for 15 minutes and for the next
11