Package Contents - Geutebruck G-Cam/EWPC-5240 Installationsanleitung

G-Cam/EWPC-5240, G-Cam/EWPC-5250
1.2

Package Contents

Please check the package containing the following items listed below.
Installation Manual
Bullet IP Camera (cable included)
5-Pin Alarm Terminal Block
Plastic Screw Anchor (x5)
M4 Self-Tapping Screw (x5)
NOTE: To use an external power supply, please contact the camera
manufacturer to confirm that the power supply complies with the LPS
requirements and shares the same power specifications with the camera.
NOTE: The supplied self-tapping screws are for soft substances /
materials such as wood. For other installation environments such as
cement wall, users MUST pre-drill and use plastic anchors before
fastening the supplied self-tapping screws on the wall.
NOTE: Do not replace batteries of the camera. Risk of explosion may
occur if the battery is replaced by an incorrect type.
2-Pin Power Terminal Block
M5 Standard Screw (x1)
Quick Guide
7
Back to the
table of contents