Unpairing An Energiser; Monitor And Control The Energiser - VOSS.farming 41404 Bedienungsanleitung

INSTRUCTION MANUAL VOSS.FARMING REMOTE CONTROL
ƒ Switch off the RF energiser and keep the on/off button
pressed for more than 5 seconds. The status LED flashes
quickly and the energiser is in pairing mode.
2.
To switch the remote control to pairing mode, press and hold
the button (13) for a few seconds until a "P" appears on the
display.
3.
Use the
4.
Keep a distance of approx. 20cm between the remote
control and the energiser.
5.
To pair the devices, press the button briefly (13).
When the devices are successfully paired, the remote control
returns to the main display and the energiser goes into RF off
status.
I nfo
If pairing is not successful, repeat the steps.

7.2 UNPAIRING AN ENERGISER

1.
To remove an energiser from the list and disconnect it from
the remote control, follow the steps in section 7.1 without
the energiser.
I nfo
As soon as the remote control does not find the energiser
during the process, the energiser is deleted from the list.
2.
To exit pairing mode on the remote control, press the
button (15).

7.3 MONITOR AND CONTROL THE ENERGISER

Via the remote control you can:
∙
check the pulse voltage of the energiser and the battery voltage
of the connected battery. Change the display of the measured
values via the
Info
Deviations of +/- 10% are within the tolerance range for
the displayed value.
∙
adjust the power of the energiser (full/half) via the
button (10).
∙
switch the energiser on or off using the
41404 - 06.2022 - V1
buttons to select a number for the energiser.
button (5).
button (17).
17
DE
EN
FR
IT
NL
SV
ES
PL