Getting Started - Flymaster M Serie Kurzanleitung

Getting started

Power ON - Short press Power button and confirm with Enter.
Power OFF - Long press Power button. Choose yes using the cursor but-
tons in the pop-up menu, and press Enter.
Enter in the main menu - In any page, Short press Menu/esc button
to access main menu.
Navigate in main menu -Use cursor buttons to navigate on the Menu.
Press ENTER to choose the desired option. To exit from any option Short press
Esc.
Set sound volume - Short press Sound button, use left and right cursor
to adjust the sound level. Press Enter to confirm, or wait 4 seconds.
Check GPS Status (GPS M only) - Use cursor buttons to navigate
on the Menu. Press ENTER to choose the GPS from the main menu. Short
Press Esc to exit.
Calibrate compass - Use the cursor buttons to navigate the Menu.
Press ENTER to choose Calibrate Compass from the main menu. Press EN-
TER to calibrate. Rotate the instrument slowly in all possible axes freely. A 20
second countdown will be visible as the calibration status. During and after
the process, the result of the calibration quality is shown, which varies from
low, medium or high. The process ends with the message "calibration ended".
Repeat as many times as necessary until you possibly get a better result, which
will be HIGH.
Set altimeter - Use cursor buttons to navigate on the Menu. Press ENTER
to choose the SET ALTIMETER from the main menu. On the pop-up menu use
Right and Left buttons from the cursor to choose from QNH, Get from GPS,
Altitude 1 (main altimeter) or Altitude 2. Use Up and Down buttons to change
the values. Press ENTER to accept. Keep pressing ENTER to accept all values
and exit or press ESC to a Quick exit.
Hardware reset - Press both Sound/Power button and Menu/esc at same
time for about 2 seconds. The instrument should reset it self showing a quick
progress bar.
Zoom in maps page (GPS M only) - In any page containing a map,
Long press Menu/Esc/Zoom button. In the right left hand corner of the map, a
magnifier icon will be shown, indicating the zoom mode is set. Use UP (zoom
in) and DOWN (zoom out) keys. If no key is pressed the zoom mode will auto-
matically be disabled after 5 seconds.
Change page - In flight mode, short press ENTER button to switch pages.
Route Navigator (GPS M only) - Use cursor buttons to navigate
on the Menu. Press ENTER to choose the ROUTE NAVIGATOR from the main
menu. Use the Up and Down buttons to choose the Waypoint that you want to
navigate. Press Enter to confirm.
6