Using The Device; Settings; Test - Eaton PKZM0 /XTPR BC1NL Serie Handbuch

4 Using the device

4.1 Settings

4 Using the device
4.1 Settings

4.1.1 Test

36
The rated motor current must be set on PKZM0-.../XTPR...BC1NL and
PKZM0-...-T/XTPT...BC1NL by means of the current dial a (￫ table 1,
page 26) prior to initial commissioning of the motor-protective circuit-breaker.
The motor-protective circuit-breaker is equipped with a testing feature b
(￫ Figure 1, page 25). The active PKZM0-.../XTPR...BC1NL and
PKZM0-...-T/XTPT...BC1NL motor-protective circuit-breaker is tripped by
actuating the test release with the help of a screwdriver.
This opens all main contacts and thus removes the output lines from the
voltage source.
DANGER

Faulty devices must not be opened and repaired.
They must be replaced by specialist personnel.
WARNING

If the motor-protective circuit-breaker is installed at a cool
location (e.g. -5 °C) und the motor is installed at a warm motor
location (e.g. 40 °C), it is possible that there will be a delayed
release during an overload if the devices are operated in the
lower current setting range.
PKZM0-.../XTPR...BC1NL, PKZM0-...-T/XTPT...BC1NL 01/22 MN03402003Z-DE/EN www.eaton.com