Hyundai HHE272006 Bedienungsanleitung Seite 2

POSITION THE SOUNDBAR CORRECTLY
Place the sound bar horizontally on a flat surface such as a TV
unit or shelves and align it centrally with the TV screen. Allow
some space between the speaker and the wall.
Don't place inside a cabinet or an walled shelf. Follow this
guidance for best sound output and good airflow around the
sound bar.
MOUNT ON THE WALL
WARNING: If you don't feel confident to correctly and
securely wall-mount the sound bar, seek the assistance of an
experienced person or professional. Install the speaker on
a vertical, fast, reinforced area of wall. For plaster walls, it is
recommended to screw into wall studs for greater security. For
optimum performance, allow at least 25mm/1''distance between
the sound bar and the TV.
FOLLOW BELOW STEPS TO MOUNT THE SOUND BAR ON
THE WALL
1. Make 2 holes on the wall with distance same as the wall
bracket on the soundbar
2. Put the plastic anchors onto the wall and secure the screws
to the plastic clip, do not tighten the screws all the way make
sure leave some space
3. Attached the 2 EVA pads onto the wall mount backet. This will
make sure that there is enough room between the wall and
the soundbar outlet.
4. Fix the screws securely and slide the soundbar on the
screws.
FOLLOW BELOW STEPS TO MOUNT THE SURROUND
SPEAKERS ON THE WALL
1. Make 2 holes on the wall with distance of two surround
speakers you needed.
2. Put the plastic anchors onto the wall and secure the screws to
the plastic clip, do not tighten
the screws all the way make sure leave some space
3. Attached the 2 EVA pads onto the wall mount backet. This will
make sure that there is enough
space between the wall and the surround speakers outlet,
minimum 15mm
4. Once the screws securely fastened, hang the surround
speaker over by inserting the screws onto the wall mount
bracket
SETTING THE SURROUND SET
1. Plug in the power cord and the display will light up (Standby
mode)
2. Switch on the surround set by pressing "STANDBY" button on
sound bar or on remote controller.
After switching on, the default input mode will appear on display.
3. Input modes can be changed by pressing the "INPUT" button
on sound bar or on remote controller.
4:Below are input mode names appearing in the display:
BL: Bluetooth Pairing mode
AUX mode
Optical mode
HDMI mode
USB mode
POWERING ON/OFF
5. Plug the power cord of surround set into a wall outlet, it will
automatically enter standby mode.
6. Short-press the "STANDBY" button on the subwoofer or on
remote controller to turn on the surround set.
7. To turn off, press and hold the "STANDBY" button for 2
seconds, then unplug from wall outlet.
NOTE: THE SOUNDBAR AUTOMATICALLY GOES BACK TO
STANDBY MODE WHEN AUDIO HAS STOPPED AND YOU
HAVE NOT PRESSED ANY BUTTONS FOR 25 MINUTES.
(BT)
(AUX)
(OPT)
(Hd)
(USb)