Assembly - Ohyama Woozoo TWF-C82T Bedienungsanleitung

Assembly

Since the tower fan is packaged after
disassembly, please follow the instructions
below for assembly.
※ Packaging and cushioning materials
are required for storing the tower fan, so
please properly keep them together with
the independent packaging box.
● Do not connect the power
plug until the assembly and
installation are completed.
● Do not run this product until
Notice
the assembly is completed.
Remove the fixed screws on the
base out of the product
• Please place the product horizontally
and remove the screws installed on
the bottom. (3 screws)
Assemble the base
• P l e a s e t h re a d t h e p owe r c o rd
through the hole in the center of the
base for assembly.
• Please insert the projected parts of
the base (rear) into the holes (4) of
the base (front) until the grippers (4)
of the base (rear) are firmly inserted
into the base (front).
Projected part
Gripper
Base (rear) Thread the
power cord
Install the base on the body
• Align the screw holes on the base
※ Please align the front and rear of the
※ If the body is placed on the floor
Notice
Thread the power cord through
the power cord plate
Base (front)
※ After assembly, please place it in a
Hole
※ This product is set with oscillating
7
with the screw holes at the bottom of
the body and fasten with the screws
removed.
body and the base, otherwise it cannot
be installed.
horizontally, the base cannot be
installed. Please hold up the body
onto the table to install the base.
● Do not place the power
cord between the body
and the base.
Power cord
plate
Power cord
level place and check if the base is
firmly fixed.
mechanism, which causes the body
to slightly wobble under normal
circumstances.