Other Symbols In This Documentation; Units Of Measurement; General Safety Instructions; Intended Use - STIEBEL ELTRON WPSV 25-4 Installationsanleitung

INSTALLATION
General information
INSTALLATION
1. General information
The chapter "Installation" is intended for qualified contractors.
Note
Read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on the instructions to any new user if required.
1.1

Other symbols in this documentation

Note
General information is identified by the adjacent sym-
bol.
f Read these texts carefully.
f
Symbol Meaning
Material losses
!
(appliance damage, consequential losses and environ-
mental pollution)
Appliance disposal
f This symbol indicates that you have to do something. The f
action you need to take is described step by step.

1.2 Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
Only a qualified contractor should carry out installation, com-
missioning, maintenance and repair of the appliance.
2.1

General safety instructions

We guarantee trouble-free function and operational reliability
only if original accessories and spare parts intended for the
appliance are used.
2.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.
WPSV

2.3 Intended use

The brine manifold is designed to distribute the brine in the
geothermal collector or in the geothermal probe. Any other
use beyond that described shall be deemed inappropriate.
Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.

3. Product description

The brine distributor comprises a brine return distributor with
tightly closing shut-off valves and a brine flow distributor with
flow regulating equipment and shut-off function.
The connections of the individual brine circuits to the brine
flow and return distributor can be individually shut off.
The individual brine circuits are connected using locking ring
fittings.
Every brine manifold is fitted with an air vent valve.
8
7
6
1 Air vent valve
2 Heat pump return
3 Brine return distributor
4 Heat pump flow
5 Brine flow distributor
6 Locking ring fitting
7 Flow meter
8 Shut-off valve
4. Installation
Material losses
!
To safeguard the tightness of the locking ring fittings,
insert all pipes vertically and free from stress into the
locking ring fittings.
f Use pipe clips. f
Pay particular attention when threading the flow and return
pipes into the brine manifold.
f Use hemp as the sealing material. f
1
2
3
1
4
5
| 7